BATTERY BOXES

• Corrosion-resistant ;• Vinyl-coated low carbon steel ;• Secures battery to small or large replacement battery tray (sold separately) ;• Adjustable size ;• 5/16" threaded fits battery width 4.5"-7";• Includes two 8.5" J steel bolts & wing nuts;

• Water-resistant ;• Panel or surface mounted;• Complies with SAE JI625;• Includes terminal cover;• Each;• 100A;

• Water-resistant ;• Panel or surface mounted;• Complies with SAE JI625;• Includes terminal cover;• Each;• 200A;

For over 50 years, Crown Automotive has been the leading manufacturer and distributor of replacement parts for Jeep® vehicles. With over 8,000 different part numbers, including many factory-discontinued items, we offer you exceptional quality that is only matched by an exceptional warranty.

Replace a worn or corroded screw/nut on top post terminals. Fits positive or negative posts. Includes hex nuts. Top post battery cables (6 and 12 volt only). This item cannot be shipped to APO/FPO addresses. Please accept our apologies

The TG Battery Box will keep your battery where you want it, even on the toughest rocks and trails. We have all seen the results of batteries not held in place securely, or held in place by bungie cords: fire and sparks. The TG Battery Box can either be welded or bolted into place. It is made out of 1/8” thick steel and is shipped unpainted. Once the TG Battery Box has been mounted you simply remove the three bolts and the top lifts off and allows you to remove or install the battery in minutes. The TG Battery Box can either be mounted where your OEM battery was, or, due to its "flat back" design, it can be mounted behind your seat or cab. Also present on the TG battery box are 9 ¼” mounting holes in the bottom for ease of installation. The TG Battery Box works with Diehard Platinum and Odyssey DT 34/78 size batteries.

Throw away those leaky rubber grommets! Daystar’s Firewall Boot is the BEST way to run wires, hoses, and other lines through your vehicle’s firewall. Simply drill a 1.25” diameter hole in the firewall and install the boot. Run your wires, trim the boot as necessary, and secure the assembly with a zip tie. It’s that easy!